What are the tool requirements for CNC shears?

What are the material requirements for CNC shears?

1. The bonding temperature of anti-adhesive cemented carbide is higher than that of high-speed steel, so it has higher resistance to adhesion and wear resistance.

2. Hardness: A lot of hard carbides are contained in the near-hardness. Its hardness is much higher than that of high-speed steel. The higher the near-hardness, the better the wear resistance.

3. Toughness The toughness of cemented carbide is much lower than that of high speed. It is not suitable for use under strong impact and vibration.

4. Thermal physical properties The thermal conductivity of cemented carbide is higher than that of high-speed steel.

What are the tool requirements for CNC shears? What are the hydraulic cleaning measures for hydraulic shears?

CNC Shearing Machine

Measures to keep the hydraulic system clean for hydraulic shears:

1) Keep the system clean and replace the oil and filter regularly. A good hydraulic oil contains a variety of additives, these additives can prevent oil deterioration or block system parts. However, these additives will lose their effectiveness after a period of time. Therefore, the oil should be changed regularly to ensure that the additives are effective. The filter can only absorb a limited number of dirt particles and other impurities from the oil. Replace the filter according to the recommended cycle to keep the system clean.

2) Keep the hydraulic oil clean. Store the oil in a clean place. Be careful when changing or refueling. Only use a clean funnel equipped with a fine mesh filter to pour oil from the container into the tank. Of course, the oil you use must be the type recommended by the equipment manufacturer.

3) Keep the work area clean. When filling or refilling the oil tank, make sure that the area around the filter box cover is clean. Only use clean oil and funnels or containers. Never bring dirt into the system—only clean oil. When maintaining the hydraulic system, only clean plastic bulkheads can be used to seal the ends of the pipeline. When maintaining hydraulic components, the workbench must be absolutely clean. Check the condition of the tools used. They should also be very clean.