CNC Bending Machine Factory

What are the components of the CNC bending machine mold? What are the safety requirements for the operation of the bending machine?

CNC bending machine

So what are the issues that need to be paid attention to in the process of using the bending machine mold? The staff should pay attention to the fact that each time the bending machine is used, the oil pump must be started. When the oil pump is in a stable operating state, other operations can be carried out. When the oil pump is unstable, start to set the parameters or adjust the stroke, which will affect the work efficiency, and the staff need to pay attention to these problems.

In addition, the choice of the notch when using the mold of the bending machine is also very critical. Many of the operations that cannot be achieved during the processing and production period are caused by improper selection of the notch. Generally speaking, the setting of the notch is related to the choice of material, and It must be in a certain proportion to the thickness of the material, and the specific needs to be determined in conjunction with the actual production situation, and the staff also need to master specific operating skills and methods.

In the process of using CNC bending machine molds to compact the plates, the staff should pay attention to the correct method and process to avoid danger or other losses caused by improper methods.

It is easy to judge whether the copper sleeve of the fuel injector is damaged. First, check whether the oil in the fuel tank becomes turbid. If you can’t see clearly in the fuel tank, you can check the water collection cup of the filter. You can see the antifreeze directly there. If you find it inside If there is antifreeze, it can basically be determined that the copper sleeve of your 663 copper sleeve injector is damaged. From the theoretical analysis of the friction torque, when the contact angle is 60°, the friction torque is the smallest. Therefore, it is recommended that for sliding bearings with a speed higher than 500r/min, a contact angle of 60° and a sliding bearing with a speed lower than 500r/min should be used. The contact angle can be a standard copper sleeve of 90° or 60°

Continuous work, working temperature less than 40: Shaft speed <200r/min, lubrication cycle once a day; Shaft speed> 200r/min, lubrication cycle once per shift. At present, the products have been widely used in 10-1 copper metallurgical continuous casters, steel rolling equipment, mining machinery, ships, steam turbines, water turbines, injection molding machines and equipment production lines. The metal substrate bears most of the load during the friction process. After installation, the equipment is operating normally. If there is a problem, it is also very important to disassemble and inspect it in time.