CNC Press Brake Characteristic and safe operation

CNC Press Brake is welded by the whole steel plate,adopts the vibration after tempering to eliminate the stress, and the frame stability is good; the machine tool is shot peened and rusted; the frame is formed by one-time clamping and forming by the imported three-dimensional machining center, ensuring the parallelism of the installation surfaces Degree and verticality.

Anhui Yongya feels that the computer controls the flow and pressure of the Y1 and Y2 cylinders through two sets of servo bidirectional pump systems. The oil in the upper cavity of the cylinder is directly pumped into the lower cavity of the cylinder through the oil pump to achieve the upper mold lifting, and the oil pump is reversed to lower the cylinder. The oil in the cavity is directly injected into the upper cavity of the cylinder to realize the bending of the sheet material. The left and right synchronization of the upper die of the machine tool is controlled separately by two sets of servo bidirectional pumps. The machine tool not only has high precision, energy saving, low noise, but also is more stable and reliable, and uses less oil, which is conducive to the manufacture of large-stroke and ultra-high-speed bending machines.

Safety operating rules of hydraulic sheet metal bending machine, its main contents are:

(1) The relevant operators should undergo strict training and assessment, and can only work after passing the assessment, otherwise they cannot.

(2) Machinery and equipment should be kept clean and tidy, their lubrication should be kept good, and the amount of oil in the tank should be checked regularly, and the amount of oil should be added in time.

(3) The bending force of the workpiece should not be greater than the nominal pressure of the equipment, and the die mouth should be selected appropriately, and the size should be moderate, without deviation.

(4) The sheet to be bent should be placed in the middle of the bending machine, and the bending machine should not be loaded on one side, so as not to affect the bending effect of the workpiece, and the accuracy of the bending.