Hydraulic Press Brake Machine commissioning method

Nowadays, many factories will apply the press brake machine in their daily production, and it has become a popular machine in the industrial manufacturing industry, so why is it so popular?

Tips for using Hydraulic press brake machines.

1. In good bending must be done before the material survey and the overall environment, many dangerous locations or items must be marked in a timely manner, only then can guarantee that the actual operation can be done better.

2. To use the press brake machine should be carefully carefully each part, fully prepared for future work, if the work, but also not the full load. Machine running load easily, to seize the time to improve bending efficiency, as far as possible to make the machine run continuously.

3. In the maintenance of the press brake machine must be disconnected from the drive and in the engine off well, so as to ensure not only the actual operation of the safety of employees’ lives, and can better ensure the good use of machinery.

4. Daily life maintenance focus on troubleshooting and the whole machine to do a good job of lubrication, regulation. The whole machine lubrication point using a phased rotation of the way, the drum, the main drive intermediate shaft, after the drive intermediate shaft and other components should be focused on maintenance.

Commissioning method of hydraulic press brake machine.

Hydraulic press brake machine in the use of some problems may require debugging, the following is the specific debugging method is introduced, take a look at it.

1. When the hydraulic press brake machine installed off the level of calibration, first wipe the hydraulic press brake machine sliding and processing surface at the anti-rust oil, and carefully cleaned, in accordance with the equipment lubrication chart, the sliding place according to the requirements of refilling the appropriate lubricant.

2. Check the coupling firm bolts to prevent loose due to transport and lifting affect the use of hydraulic press brake machine and safety.

3. Clean the oil tank, check the strainer, and refill the hydraulic oil in sufficient quantity as required. According to the manual, refill the hydraulic oil at the oil pump return.

4. Check the electrical parts, make sure there are no safety hazards after accessing the power supply, start the motor, confirm the oil pump is turning correctly, and then run the air for three minutes.

5. The electrical button selected to the point position, step down the foot switch, so that the hydraulic press brake machine in the case of no load up and down several working trips to check whether the electrical and hydraulic components work properly.

6. Test bending plate: according to the plate thickness and length, choose a reasonable lower die V-groove and hydraulic press brake machine pressure. Test bending plate should be thin after thick, the pressure should be small after large, in order to check the implementation of the order of the components everywhere.