Hydraulic sheet metal bending machine commissioning method

Hydraulic sheet metal bending machine commissioning method

Now many factories for daily production, will be applied to their actual production bending machine, it has become a popular machine in the industrial manufacturing industry, so why is it so popular?

CNC bending machine when using the skills.

1. In good bending must be done before the material survey and the overall environment, many dangerous locations or items must be marked in a timely manner, only so you can guarantee to do a better job of actual operation.

2. To use the bending machine should be carefully carefully each part, fully prepared for future work, if the work, but also not the full load. Machine running load easily, to seize the time to improve bending efficiency, as far as possible to make the machine run continuously.

3. In the bending machine maintenance must be done after disconnecting the drive and engine off, so as to ensure not only the actual operation of the life of the staff safety, and can better ensure the good use of machinery.

4. Daily life maintenance focus on the exclusion of the fault found and the whole machine to do a good job of lubrication, regulation. The whole machine lubrication point using a phased rotation of the way, the drum, the main drive intermediate shaft, after the drive intermediate shaft and other components should be the focus of maintenance.

Hydraulic plate bending machine debugging method

Hydraulic sheet bending machine in the use of some problems may need to be debugged, the following is a specific debugging method is introduced, take a look.

1. When the hydraulic bending machine installed off the calibration level, first wipe away the hydraulic bending machine each sliding and processing surface at the antirust oil, and carefully cleaned, in accordance with the equipment lubrication chart, the sliding places as required to refill the appropriate lubricant.

2. Check the coupling firm bolts to prevent loose due to transport and lifting affect the use of hydraulic bending machine and safety.

3. Clean the oil tank, check the filter, and refill a sufficient amount of hydraulic oil as required. According to the manual, the oil pump oil return to fill the hydraulic oil.

4. Check the electrical parts, to determine the absence of any safety hazards after access to power, start the motor, confirm that the oil pump is turned correctly, the air rotation for three minutes.

5. The electrical button selected to the point position, step down the foot switch, so that the hydraulic bending machine in the case of no load up and down several working trips to check whether the electrical and hydraulic components work properly.

6. Test bending plate: according to the plate thickness and length, choose a reasonable lower die V-groove and hydraulic bending machine pressure. Test bending plate should be thin after thick, the pressure should be small after large, to check the implementation of the order of components everywhere.